Dear Editor,
The past few months have shown an increasing incidence of transmission of SARS-CoV-2 from patients to health care providers (HCPs). Figures from China's National Health Commission show that more than 3300 HCP's had been infected as of early March. In Italy, 20% of responding health-care workers were infected.1 It is important to protect staff from transmission during high-risk procedures like tracheal intubation. The cognitive aid (Fig. 1) formulated, suggests the following 10 P's as a series of steps for safety sequence intubation in Coronavirus Disease (COVID) 19 patients, with the intent to simplify the substantial amount of information currently related to COVID-19 in scientific literature.
1.
Protection: All aerosol generating procedures (AGPs) are to be done in negative pressure isolation rooms with minimum personnel involved. WHO's interim guidance published on March 19th, on “Rational use of personal protective equipment for COVID-19” recommends, AGP-PPE to include respirator N95 or FFP2 standard, or equivalent, gown, gloves, eye protection and apron.2

2.
Planning: Assign roles and responsibilities, plan the airway management strategy before entering the isolation room. Quick airway assessment of the patient can be done using MACOCHA score.3 Subsequently airway plan (plan A to plan D) can be tailored by the team to achieve successful intubation in the first attempt. The team members should practice closed loop communication and watch for cross-contamination.

3.
Preparation: This step involves preparation of patient specific airway equipment kit and drugs outside the isolation room. Cricothyroidotomy kit can be kept outside with the runner. Once inside the isolation room, check and assemble equipment using mnemonic SOAP ME (Fig. 1).

4.
Position: Appropriate positioning of the patient recommends 30-degree head up to improve oxygenation and ramp position in the obese to ease intubation.

5.
Pre-oxygenation: An appropriately sized well-fitting mask applied to the patient's face using 2-person, 2-handed VE-grip for a better seal.4 The preferable circuit is a closed dual limb circuit or rebreathing circuit like Mapleson's C (Waters’) or coaxial modification of Mapleson's D (Bain's).

6.
Pre-treatment: Judicious hemodynamic resuscitation can be undertaken.

7.
Pressure: We recommend it to be used only when a trained assistant is available as it can cause difficulty in glottis visualization if not properly applied.

8.
Paralytics and induction: Purpose is to ensure adequate depth and avoid coughing. Avoid positive pressure ventilation before securing the airway to prevent potential aerosolization of virus present in the airway.

9.
Placement of tube and confirmation: Laryngoscopy should be undertaken with the device most likely to achieve prompt first pass successful tracheal intubation. Using a video laryngoscope is recommended. Additional barrier like plastic sheet tent or box may be used. Use a standard failed tracheal intubation algorithm with a cognitive aid if difficulty arises.

10.
Post-intubation management: Avoid circuit disconnection – push twist all connections. If the disconnection of circuit is warranted, then always disconnect with filter or apply tube clamp to the endotracheal tube before doing so. Seal all used airway equipment in a double zip-locked plastic bag. Clean the room 20 minutes after tracheal intubation (or last AGP).

Airway management of COVID-19 patients involves specific challenges of risk of infection to HCPs and rapid desaturation of patients during apnea leading to added stress if patient's airway is not handled smoothly in the first attempt of intubation. The positive impact of cognitive aids and checklists in anesthesia has been investigated by a number of studies.5 These studies have kept patient's safety as foremost priority. In conclusion, an adequate balance has to be maintained between the safety of HCPs and management of COVID-19 patients.