Polímeros: Ciência e Tecnologia
https://app.periodikos.com.br/journal/polimeros/article/doi/10.1590/S0104-14282003000100011
Polímeros: Ciência e Tecnologia
Scientific & Technical Article

Avaliação da Incorporação de Resíduo de Poli(Etilenoco- Acetato de Vinila) em Borracha Nitrílica

Evaluation of Waste Poly(ethylene-co-vinyl) Incorporation in Nitrile Rubber

Moreira, Viviane X.; Soares, Bluma G.

Downloads: 0
Views: 954

Resumo

A influência do resíduo de poli(etileno-co-acetato de vinila) (EVAR) no desempenho mecânico de composições vulcanizadas de NBR foi estudada. A concentração ótima de EVAR, a qual apresentou maior valor de tensão na ruptura, foi de 50 phr. Além disso, a influência do EVA e do EVAR funcionalizado com grupos tióis (EVALSH) e do EVAR modificado com anidrido maleico (EVARCO) como agentes compatibilizantes foi estudada. O copolímero EVALSH atuou como acelerador no processo de vulcanização, sendo observado um decréscimo do tempo de vulcanização. Uma melhora na resistência ao envelhecimento também foi observada. A adição de 10 phr de EVARCO resultou na redução do tempo de vulcanização e em uma melhora na maior parte das propriedades avaliadas. As propriedades termodinâmico-mecânicas foram avaliadas por análises de DMTA. Os estudos da interação entre a fase dispersa e a fase matriz foram realizados utilizando-se microscopia eletrônica de varredura (MEV).

Palavras-chave

Composições elastoméricas, resíduo de EVA, propriedades mecânicas, compatibilização

Abstract

The influence of poly(ethylene-co-vinyl acetate) (EVA) waste (EVAR) on the mechanical performance of NBR vulcanisates compounds was studied. The optimum concentration of EVAR, which has presented higher ultimate tensile stress, was found at 50 phr. In addition, the influence of EVA and EVAR functionalized with mercaptan groups (EVALSH) and EVAR functionalized with maleic anidride (EVARCO) as compatibilizing agents was studied. The copolymer EVALSH acted as accelerator for the curing system, since a decreasing of the curing time was observed. An improvement of ageing resistance was also observed. The addition of EVARCO resulted in a reduction of the curing time and an improvement of most of evaluated properties. The thermodynamic-mechanic properties were investigated by DMTA analysis. The studies on the interaction between dispersed phase and matrix were performed by scanning electron microscopy (SEM).

Keywords

Elastomers compounds, EVA waste, mechanical properties, compatibilization

References



1. Debapriya, D.; Sukumar, M.; Adhikari, B.- Journal. of Applied Polymer Science, 73, 2951 (1999).

2. Varghese H.; Bhagawan S. S.; Someswara Rao S.; Thomas S.- European Polymer Journal, , 31, 957 (1995).

3. Koshy, A T.; Kuriakose, B.; Thomas, S. - Polym Degrad Stab, 36, 137 (1992).

4. Koshy, A T.; Kuriakose, B.; Thomas, S.; Premaltha, C. K.; Varguese, S. – Journal of Applied Polymer Science, 49, 901 (1993).

5. Kundu, P.P.; Tripathy, D. K – Kautsc Gummi Kunstst, 49, 268 (1996).

6. Kundu, P.P.; Tripathy, D. K; Gupta, B. R.– Journal of Applied Polymer Science, 63, 187 (1997).

7. Kundu, P.P.; Tripathy, D. K – Kautsc Gummi Kunstst, 49, 666 (1996).

8. Kundu, P.P.; Banerjee, S.; Tripathy, D. K – Int Journal Polym Mater, 32, 125 (1996)., 49, 666 (1996).

9. Bandyopadhway, G. G.;Bhagawan, S.S.; Ninan, K.N.; Thomas, S. – Rubber Chem Technol, 70, 650 (1997).

10. Koning, C.; Van Duin, M.; Pagnoule, C.; Jerome, R. – Prog Polym Sci , 61, 591 (1996).

11. Dutra, R.C.L.; Lourenço, V.L.; Diniz, M.F.; Azevedo, M.F.P; Barbosa, R.V.; Soares, B. G.- Polym Bulletin, 37, 215 (1996).

12.. Ishiaku U.S.; Chong C.S.; Ismail H.-Polymers & Polymers Composites, 6, 399 (1998).

13. Kim J. I.; Ryu S. H.; Chang Y. W. – Journal of Apllied Polymer Science, 58, 101 (2000).

14. Kuczkowsky J. A – Encyclopedia of Polymer Science and Engineering, editado por Mark H. F., Bikales N. M., Overberger C.G. e Menges G.; John Wiley & Sons, New york, vol.17, p. 716.

15. Coran A Y.- Encyclopedia of Polymer Science and Engineering, editado por Mark H. F., Bikales N. M., Overberger C.G. e Menges G.; John Wiley & Sons, New york, vol.17, p. 666.

16. Boonstra B. B. – Polymer, 20, 691 (1979).

17. Sombatsompop N. – Journal of .Applied Polymer Science, 74, 1129. (1999).

18. Pimblott J. G.; Scott G.; Stuckey E. – Journal of Applied Polymer Science, 69, 865 (1975).



588370ee7f8c9d0a0c8b4643 polimeros Articles
Links & Downloads

Polímeros: Ciência e Tecnologia

Share this page
Page Sections